Hangzhou Xingguan Machinery Co., Ltd

Professional Wire Machinery Supplier in China

Home > Exhibition > Content
How do I operate the wire drawing machine?
- Jan 18, 2018 -

Wire drawing machine is also called wire drawing machine, is the use of mechanical equipment is widely used in industry, widely used in machinery manufacturing, metal processing, petrochemical, plastics, wood products, such as wire and cable industry.

Drawing machine can be divided into metal wire drawing machine (for the production of prefabricated metal parts such as fasteners, plastic wire drawing machine (polyester) for the plastics industry, nylon, polyethylene, polypropylene, polyester raw materials for the production of special equipment for hollow and deep processing of the solid line or garden flat wire), bamboo (for wire drawing machine the wood products industry production of chopsticks, toothpicks, barbecue sticks out of bamboo processing equipment, etc.).

Safety operation rules of drawing machine


1.Job requirements:

(1) the operator must hold drawing machine operation qualification certificate, the operation is strictly prohibited in the unmanned machine.

(2)The operating personnel must operate in the designated production and processing equipment, non local personnel machine operation or serial operation.

(3)The basic technical parameters and performance indicators, the operator must be familiar with the equipment.

(4) the operating personnel must be loyal to duty, responsible, proficient in the operation of equipment maintenance.

(5)operators must continue to learn, and strive to improve their own quality.


2. Safe operation:

(1)The operator must wear gloves to prevent the workpiece burn fingers, affect the quality of products.

(2)We should carefully check the gas supply situation of equipment before the start (5kg / cm2), the gas supply pipeline leaks, emptying the water in air filter.

(3)The correct installation (the direction of the arrow and pull pull ribbon ribbon in the drum should move towards the direction of the arrow). Carefully check the lubricity of the upper and lower bearings and lifting screws, so that no one in front of the material can be started.

(4)The device starts immediately after the inspection is required in the belt swing range, there is no abnormal phenomenon, it should immediately adjust or shut down.

(5)It is prohibited to wire drawing machine and the dust remover to start at the same time, strictly prohibited operating personnel leave work.

(6)It is not transmitted directly to the workpiece on the conveyor belt, the conveyor belt is not strictly prohibited, wooden pallets directly drawing workpiece, so as to avoid damage to the conveyor belt and the workpiece flying out of the wound.

(7)Two operations, the following equipment operator is not in the wire drawing machine exit, so that the workpiece is flying away.

(8)The pressure regulating, drawing machine should be moderate, generally the pressure gauge should be in 35 to 75, no red line, so as to avoid the occurrence of equipment or accidents.

(9)Equipment, strictly adjust the air pressure under normal operating conditions, to avoid wear caused by loss of equipment, personal accident.

(10)I have the equipment abnormal phenomenon in operation process, should be immediately shut down, power outages, to avoid failure of expansion.

(11)These devices should be closed in the maintenance of the total power, non operation signs, to avoid accidents.

(12)We should get off work or equipment in the total power and compressed air is closed to ensure the safety of the equipment.


3. Operation requirements:

(1)The processing work to read drawings and technical documents carefully, to avoid batch scrap or waste.

(2)The work should be based on the technical requirements of drawing direction, drawing surface, pull the ribbon to carefully define the correct choice.

(3) Should wear gloves in the whole process, pay attention to protect the surface of the workpiece, the workpiece surface to prevent scratches, impact caused by waste.

(4)The strictly prohibited direct workpiece cleaning the workpiece.

(5)The finished products should be placed, gently, layered protection packaging, so as not to damage the surface of the workpiece.

(6)It timely cleaning and recycling bins, to ensure the normal work of the fan